Announcement

Collapse
No announcement yet.

CareCure Home

Collapse

Profile Sidebar

Collapse
Avatar
maddog
Senior Member
Last Activity: Today, 12:08 PM
Joined: 25 Feb 2004
Location: Clemson, SC
  •  
  • Filter
  • Time
  • Show
  • Source
Clear All
new posts

  • Bypassing the pcb is probably the best solution if you don't have the latest tailwind with the battery gauge on the chair. 10ah is enough to get through just about any day, I wish the chair had come with a larger battery from the factory. Battery life was always this chair shortcomings. I remember...
    See more | Go to post

    Leave a comment:


  • I am charging with the lithium charger. I could not get the lights to go up with the charge because you need to charge through the iglide circuit board. When you disconnect the old nimh batteries from the circuit board the lights reset to completely dead even if you install a fully charged battery....
    See more | Go to post

    Leave a comment:


  • Worked on this most of the weekend and got everything working. Took me forever but I got the lights working. I have not used it much so I don't know how well the lights will correspond to the actual state of charge. The lights work by counting amps in and amps out to keep track of how much capacity...
    See more | Go to post

    Leave a comment:


  • I redesigned the battery box and printed it and put everything together. I still need to clean some things up but it works. I used my last old battery which was a Clinton River battery with lights that worked. I disconnected the old nimh batteries with two lights showing and quickly plugged in the...
    See more | Go to post

    Leave a comment:

No activity results to display
Show More
Working...
X